Simoniz High Pressure Washer Instruction Manual download pdf (Page 19)

18

Recommendations

• Before cleaning any surface, an inconspicuous

area should be cleaned to test spray pattern

and distance for maximum cleaning results.

• Take care when using high-pressure setting as

it can potentially damage the finish or paint.

• If painted surfaces are peeling or chipping,

use extreme caution as pressure washer may

remove the loose paint from the surface.

• The best angle for spraying high-pressure

water against a cleaning surface is 45°.

Spraying directly head-on tends to cause dirt

particles to embed in the surface.

Deck Cleaning

With Detergent: Fill detergent bottle with

Deck/Fence Cleaner (39-4577-4). Place deter-

gent suction tube directly into cleaning solution

and apply to surface at low-pressure. For best

results, limit your work area to smaller sections

of approximately 25 sq.ft. Allow Deck Wash to

remain on surface 1 to 3 minutes.

Do not allow

detergent to dry on surface. Rinse at high-pres-

sure in a long sweeping motion keeping the

spray nozzle approximately 6” from the cleaning

surface. Always clean from top to bottom and

from left to right. When moving on to a new sec-

tion of the cleaning surface, be sure to overlap

the previous section to eliminate stop marks and

ensure a more even cleaning result.

Without Detergent: Pre-rinse cleaning surface

with fresh water and wash with water on

high-pressure using same directions as above.

House Siding

With Detergent: Fill detergent bottle with

House/Siding Cleaner (39-4576-6). Place deter-

gent suction tube directly into cleaning solution

and apply to surface at low pressure (for best

results, limit your work area to sections of

approximately 6’ and always apply detergent

from bottom to top). Allow detergent to remain

on surface 1–3 minutes.

Do not allow detergent

to dry on surface, if surface appears to be dry-

ing, simply wet down surface with fresh water.

Rinse at high-pressure from bottom to top, then

top to bottom in an even sweeping motion keep-

ing the spray nozzle approximately 6” from the

cleaning surface.

Without Detergent: Pre-rinse cleaning surface

with fresh water and wash with water on

high-pressure using same directions as above.

Cement Patios, Brick & Stone

With Detergent: Fill detergent bottle with

Heavy-duty Degreaser (39-4578-2). Place deter-

gent suction tube directly into cleaning solution

and apply to surface at low-pressure. For best

results, limit your work area to smaller sections

of approximately 25 sq.ft. Allow degreaser to

remain on surface 1–3 minutes.

Do not allow

detergent to dry on surface. Rinse at high-pres-

sure in a sweeping motion keeping the spray

nozzle approximately 3–6” from the cleaning

surface. Always clean from top to bottom and

from left to right.

Without detergent: Pre-rinse cleaning surface

with fresh water and wash with water on

high-pressure using same directions as above.

TIPS ON CLEANING WITH YOUR PRESSURE WASHER

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments