Simoniz High Pressure Washer Owner's Manual download pdf (Page 20)

20 | P a g e

6) Cover the pressure washer and store it in a

clean, well ventilated and dry place. Ensure

storage area is at room temperature.

*** See in-store to purchase fuel stabilizer or

pressure washer antifreeze.

If you wish to drain the fuel instead of adding

fuel stabilizer, please follow these steps:

1) Turn fuel shut-off valve to the “OFF” position.

Remove drain hex bolt (A) from the carburettor

(B).

2) Now turn fuel shut-off valve to the “ON” position

and drain the fuel from the tank, carburettor and

hose.

3) Replace the carburetor drain

hex bolt once

the fuel is completely drained.

PREVENTING FREEZING DAMAGE:

• If your pressure washer is subjected to

freezing temperatures, damage could occur.

This type of damage is not covered under

warranty. To avoid possible damage, a small

amount of antifreeze can be used.

• Place the unit on its side with the water inlet

facing upwards. Pour 1/4 cup of antifreeze

into the water inlet.

• Disconnect spark plug wire, and then pull

recoil starter several times to circulate the

antifreeze in the pump system. Reconnect

spark plug wire.

•

It is also important to make sure the wand and

all hoses are disconnected and drained of all

water or th

ey may burst.

• When taking pressure washer out of storage,

run water through the system until it runs

clear.

1 2 ... 15 16 17 18 19 20 21 22 23

No comments

Simoniz High Pressure Washer Owner's Manual Page 20